DIY Top Hat
- 1). Choose a second color of craft felt. The usual choices are white, silver or a shiny black.
- 2). Cut two brim pieces, three bands and one top piece of the black craft felt. The brim is a circle 15 inches in diameter. The two bands should be 24 inches by 3.5 inches. The top piece should be a circle eight inches in diameter.
- 3). Cut one band piece of the other craft felt 24 inches by 3.5 inches.
- 4). Lay the two pieces of brim on top of each and sew them together 1/8 of inch from the outside.
- 5). Draw a 6 inch (or the diameter of your head) diameter circle with the fabric pen in the middle of the two brim pieces. Cut out that circle.
- 6). Turn the brim inside out and iron the liner, either side of the brim. Then sew the liner half an inch in.
- 7). Sew the three black bands together, edge to edge along the 24 inch side, 1/8 of an inch in. Then sew the other color band at the bottom. Unfold the bands and iron out.
- 8). Place the bands “wrong side up” on the top piece and sew them together starting an inch in. There should be an inch left over on both sides of the bands.
- 9). Turn the bands and top combo inside out and thread them through the hole in the brim. Line up the middle of the brim with the side of the bands opposite the open flap.
- 10
Sew bands/top combo to the brim starting from the middle, going right and stopping at the rear center. Then start at the middle again, going left, and stop at the rear center again. - 11
Turn the hat inside out and squash it flat so you can line up the excess parts of the bands with the top. Sew the bands together along that line. Cut off any remaining excess band fabric. - 12
Turn the hat right side out and wear it.
